# 7.1.1 Adhesive Failure

> From: LOCTITE®X Digital Manual for Bonding (https://www.loctitex.com/en/manuals/bonding/7.1.1-adhesive-failure/)

#### 7.1.1 Adhesive Failure

Adhesive failure occurs when the bonded assembly is subjected to a load that exceeds the adhesion, causing failure at the interface between the adhesive and the substrates. In this failure mode, there is visible adhesive residue remaining on one of the substrates, or it may be more localised, with each side having a piece of the adhesive layer. This localised adhesive failure often appears with adhesive segments on the two substrates mirroring each other as in Figure 209.

_Figure 208 Adhesive failure_

![Figure 208 Adhesive failure](/en/manuals/bonding/assets/img/adhesive-failure.jpg)

If this is the adhesive failure mode, a stronger bond can be achieved by reconsidering either the surface preparation or the adhesive selection.