# 5.1.3.3 Double butt Joint or Half LAP

> From: LOCTITE®X Digital Manual for Bonding (https://www.loctitex.com/en/manuals/bonding/5.1.3.3-double-butt-joint-or-half-lap/)

##### 5.1.3.3 Double butt Joint or Half LAP

The double butt joint or half lap joint is obtained by machining the ends of substrates to increase the contact surface. By increasing the contact surface, forces exerting stresses on the assembly will be distributed more evenly, thus creating a stronger joint. Generally speaking, half the depth of the material will be removed from each substrate (assuming equal dimensions) to maintain maximum substrate integrity. This joint is reasonably strong; however, it is not recommended when materials are subject to fatigue or high-impact loads. Preparing the joint is simple, but it must be fitted correctly along the entire length of the joint to ensure adequate strength.

_Figure 107 Double butt joint_

![Figure 107 Double butt joint](/en/manuals/bonding/assets/img/bonded-adhesive-joint-design-halflap-doublebutt.jpg)